About this Blog

This is about the combination of two interests, Radio Control vehicles and Science Fiction models. This blog documents my science fiction spaceship and radio controlled vehicle projects.

Thursday 21 May 2015

Toy Bash Truck

Part 2, Part 3, Part 4, Part 5


More than a year ago now I was looking at the toys in a discount store that may have interesting plastic shapes and found this rubbish truck toy which was not too expensive.

A little bit later I purchased a Bruder large tracked dozer thinking It might be fun to try and use the tracks for something. The cool thing about the Bruder range of toys is that they are all at a standard scale of 1/16 and reasonably accurate to the subject at least as far as most toys go. The pain of the Bruder toy range is that they use no screws in the assembly, its all tabs into slots with barbs that make it fiddly if not downright difficult to pull apart. Anyway it sat around in a box in bits for quite some time.


Some months later I found another of the rubbish truck toys for $3.50 at a thrift store or charity shop as its more commonly referred to in Australia.


Many more months later (only last week) I had the idea to see what would happen if I put them all together. Here is the result of that toy bashing.



Its basically the dozer cabin, back to front, joined to the combination of the two back ends of the rubbish trucks joined end to end, split down the middle and widened. A pile of 2mm styrene ties it all together. Parts off the dozer and the truck are re-purposed for detail bits and pieces along with a few kit parts, a small amount of foamed PVC and more styrene and assorted evergreen strips and textured sheet. A few of the urethane cast parts have also been employed here and there. It has a wooden frame underneath for reinforcement.
The wood is superglued to the plastic parts with thick superglue. The plastic is sanded with very coarse sandpaper to roughen the glossy surface so the superglue has something to mechanically bond to. All the PVC and Urethane parts are also superglued with a sanding treatment first.






The chassis, which is still to be completed, is based on a Venom Creeper seeing as I had a few parts still left over from the Creeper 6X6 project.
Here is the body work balanced on top of the chassis so far to give a rough idea of the way it will sit.




The yellow lump at the back is from the rear of the bruder dozer, here upside down. There is some work still to do at the back and quite a bit more to do at the front including adding a driver figure and fitting a seat. The original cockpit has been cut up as it faced the otherway. I may be able to adapt the existing seat for re-use, its not a sinple exercise at it was all molded in one at an angle with the rest of the interior. Much butchery has had to take place to extract it.
The wheels and tires are the old Axial Rockster beadlocks with Rock Lizards which, true to form, I have had sitting in a box for years waiting for a project to come along.

You can see how messy the bench gets with all the butchering and sanding of parts to get them to fit. I think I'll have to have a clean up before going much further.

More soon...

Part 2, Part 3, Part 4, Part 5

2 comments:

  1. Your attention to detail is remarkable! Glad to see you kitbashing & posting again :)

    ReplyDelete
  2. This looks like a lot of fun!

    ReplyDelete

Most Popular Posts in the Last 7 Days